The Simpson Strong-Tie CS14 strap is a continuous utility strap that can be cut to length on the job site for maximum versatility. It comes packaged in a lightweight carton (about 40 lbs) for easy handling.

• Use all specified fasteners.
• Wood shrinkage after strap installation across horizontal wood members may cause strap to buckle outward.
• Refer to the applicable code for minimum nail penetration and minimum wood edge and end distances.
• The table shows the maximum allowable loads and the nails required to obtain them.
• The cut length of the strap shall be equal to twice the "End Length" noted in the table plus the clear span dimension.

NOTE: The correct fasteners installed in the correct position must be used to achieve published load values

California Residents: WARNING

-Use all specified fasteners.
-Wood shrinkage after strap installation across horizontal wood members may cause strap to buckle outward.
-Refer to the applicable code for minimum nail penetration and minimum wood edge and end distances.
-The table shows the maximum allowable loads and the nails required to obtain them.
-The cut length of the strap shall be equal to twice the "End Length" noted in the table plus the clear span dimension.
-CMST only - Use every other triangle hole if the wood tends to split. Use round and triangle holes for comparable MST loads, providing wood does not tend to split.