Simpson Strong-Tie HDU Holdowns are pre-deflected to virtually eliminate deflection under load due to material stretch. The Strong-Tie HDU2-SDS2.5 pre-deflected holdown is installed with Simpson Strong-Drive SDS heavy duty connector screws which are included with the holdown.

• Holdown designs virtually eliminate deflection due to material strech.
• Uses Strong-Drive SDS Heavy-Duty Connector screws which install easily, reduce fastener slip, and provide a greater net section area of the post compared to bolts.
• Strong-Drive SDS Heavy-Duty Connector screws are supplied with the holdowns to ensure proper fasteners are used.
• No stud bolts to countersink at openings.

Installation:

• Use all specified fasteners.
• The HDU requires no additional washer, the DTT requires a standard cut washer (included with DTT2Z) be installed between the nut and the seat.
• Strong-Drive SDS Heavy-Duty Connector screws install best with a low speed high torque drill with a 3/8" hex head driver.



NOTE: The correct fasteners installed in the correct position must be used to achieve published load values




California Residents: WARNING

-Use all specified fasteners.
-The HDU requires no additional washer, the DTT requires a standard cut washer (included with DTT2Z) be installed between the nut and the seat. -Strong-Drive SDS Heavy-Duty Connector screws install best with a low speed high torque drill with a 3/8" hex head driver. </u