Simpson HDIA25SS 3/8" Hollow Drop-In Anchor - Zamac 3, Pkg 50
Simpson HDIA25SS 3/8" Hollow Drop-In Anchor - Zamac 3, Pkg 50
Description:
Description:
Installation:
- Installation Instructions — Solid Base (using solid setting tool):
- Drill a hole in the base material using the appropriate diameter carbide drill bit as specified in the table. Drill the hole to the specified embedment depth.
- Blow the hole clean using compressed air. Overhead installations need not be blown clean.
- Insert the HDIA into hole. Tap with hammer until flush against surface.
- Using the designated setting tool, drive the anchor to the bottom of the drilled hole. After the anchor reaches the bottom of the drilled hole, perform an additional three hammer blows against the setting tool to drive the anchor body over the cone.
- Position fixture; insert fastener and tighten.
- Installation Instructions — Hollow Base (using hollow setting tool):
- Drill a hole in the base material using the appropriate diameter carbide drill bit as specified in the table.
- Thread the HDIA onto the designated setting tool for hollow base materials.
- Insert the HDIA into the hole. Tap the setting tool until the face of the tool contacts the surface.
- Rotate the setting tool a minimum of two turns to set the anchor.
- Remove the setting tool.
- Position fixture; insert fastener and tighten.
California Residents: WARNING
Specifications:
Specifications:
Drill bit size: 5/8"
Quantity: 50
Accepts rod size: 3/8"
Length: 1-1/4"
Manufacturer name: Simpson Strong-Tie
For Treated Lumber: Yes
Product Guide: View Spec Sheet
Installation
Installation
Installation Instructions — Solid Base (using solid setting tool):
-Drill a hole in the base material using the appropriate diameter carbide drill bit as specified in the table. Drill the hole to the specified embedment depth.
-Blow the hole clean using compressed air. Overhead installations need not be blown clean.
-Insert the HDIA into hole. Tap with hammer until flush against surface.
-Using the designated setting tool, drive the anchor to the bottom of the drilled hole. After the anchor reaches the bottom of the drilled hole, perform an additional three hammer blows against the setting tool to drive the anchor body over the cone.
-Position fixture; insert fastener and tighten.
Installation Instructions — Hollow Base (using hollow setting tool):
-Drill a hole in the base material using the appropriate diameter carbide drill bit as specified in the table.
-Thread the HDIA onto the designated setting tool for hollow base materials.
-Insert the HDIA into the hole. Tap the setting tool until the face of the tool contacts the surface.
-Rotate the setting tool a minimum of two turns to set the anchor.
-Remove the setting tool.
-Position fixture; insert fastener and tighten.
Stay in touch
This is a dummy newsletter form so don't bother trying to test it. Not that I expect you to, anyways. :)
- Choosing a selection results in a full page refresh.
- Opens in a new window.