Concrete Barrier Grabs for Crane Lifts
Precast concrete barriers are heavy, awkward to rig by hand, and often set in tight work zones. A barrier grab clamps onto the top of the barrier so a crane can lift, move, and reposition each section without wrapping slings around it. This collection features the M&W barrier grab, made in the USA, with a 9,000 lb. rating for barriers 6" to 12" wide at the top.
Specifications
| Model |
WLL |
Barrier width at top |
Safety factor |
Weight |
Lifting point |
| M&W Barrier Grab |
9,000 lbs. |
6" to 12" |
3:1 |
660 lbs. |
Large lifting eye for a crane hook |
Start by confirming two things for the barriers you handle: the width across the top, which has to fall within the 6" to 12" range, and the weight of the section. Barrier sections vary by profile and length, so check the weight of your own barriers rather than assuming a number. The grab's 660 lbs. also counts against the capacity of the crane and rigging.
What the Listing Describes
-
Self-holding grip: A stainless steel indexing latch holds the clamp open, and gripping pads conform to the load.
-
Crane hook lifting eye: A large lifting eye accepts a crane hook.
-
Safety yellow finish: The bright paint helps the grab stand out on a busy site.
-
RFID chip: The grab is equipped with a chip for asset tracking.
-
American made: The grab is manufactured by M&W stateside.
Standards and Documentation
The listing states that the grab exceeds the ASME B30.20 standard as well as OSHA regulations, and that every unit is proof load tested individually with certification paperwork included. Hold on to that paperwork for your lifting files, and see the product page for exactly what ships. Use, rigging, and inspection on your own job must still follow the rules that apply there.
Where It Fits
- Setting out barrier sections along a roadway work zone
- Moving barriers around a staging yard or storage area
- Repositioning sections as a project phase changes
Lifting Barriers Safely
- Go over the manufacturer's instructions first, including how the clamp opens, seats on the barrier, and releases.
- Make sure the barrier fits within the stated width range and that the grab is seated fully before the crane takes the weight.
- Never exceed the rated capacity, and connect the crane hook to the lifting eye using equipment rated for the load.
- Keep people away from the barrier and the swing path while it is in the air.
- Check the grab before every use for cracks, bent parts, worn gripping pads, and a damaged latch. If anything is off, retire it until it is fixed.
- Use it for barrier sections only, never for lifting people.
- Damaged barriers or soft ground are good reasons to get a qualified person to plan the lift.
Rigging and Site Support
The grab connects to your crane through your own rigging. Options include wire rope slings, nylon slings, shackles, and the wider rigging hardware selection. Working on soft or uneven ground? Outrigger pads give crane outriggers a wider base. You can see the full range under rigging supplies and hardware.
Other Below-the-Hook Devices
Not lifting barriers? The material handling collection includes devices for plate, pipe, drums, pallets, and more.
Concrete Barrier Grab FAQs
What size barrier does it fit?
The listing says it handles concrete barriers from 6" to 12" wide at the top.
How much can it lift?
It is rated at 9,000 lbs.
How does it connect to a crane?
It has a large lifting eye that accepts a crane hook.
Where is it built?
It is a domestic M&W product.
Is certification included?
Yes, per the listing. Each grab is proof tested individually and comes with certification paperwork.
Is it safe to lift workers with it?
No. It is meant only for concrete barrier sections.
Need Help Choosing?
Wondering if this grab suits your barriers and your crane setup? Reach out to our Product Experts before you buy.
