Built around 1" of low-stretch polyester webbing, this ratchet strap gives you mechanical leverage instead of relying on arm strength alone to cinch down a load. End hardware is a vinyl-coated S-hook designed to grip anchor points without scratching or marring painted surfaces. Sold as a 4-pack.

Key Features

• Heavyweight polyester webbing woven with more picks per inch than typical straps on the market, for a webbing that resists abrasion, tearing, and cutting
• Cleanly heat-sealed ends that stop fraying before it starts, extending the working life of the strap
• Corrosion-resistant zinc-plated hardware built for outdoor and roadside use
• Tagged and stenciled with break strength and working load limit information to support compliance with FMCSA and DOT regulations, CVSA and WSTDA guidelines, and North American cargo securement standards

Applications

• Landscaping, construction, and job-site equipment transport
• Securing lumber, pipe, and other bundled materials
• Moving and general hauling with pickup trucks and trailers
• Everyday towing and utility trailer use

Installation

Wrap the fixed end around the anchor point and feed the free end through the ratchet mandrel, pulling out slack by hand before ratcheting. Tighten in small increments until the load is secure, then close and lock the ratchet handle. Confirm hooks are properly seated on rated anchor points, stay within the strap's working load limit, and re-check tension after the first few miles.