When a flag wears out but the dowel or pole it's mounted on is still fine, you don't need to replace the whole assembly. This 4-pack of replacement flags features grommets in two corners so you can swap them onto your existing dowels and poles, or tie them off with rope. FMCSA rules require oversize load flags to measure at least 18" x 18" in red or fluorescent orange, and these vinyl-coated polyester mesh flags meet that size while letting wind pass through to extend their working life.

Key Features

• Grommets in 2 Corners: Attaches to existing poles or dowels, or ties off with rope.
• Vinyl-Coated Polyester Mesh: Strong and durable, with airflow that reduces wind resistance and extends flag life.
• FMCSA-Compliant Size: 18" x 18" red flag meets the minimum size for oversize load flags.
• 4-Pack: Replace flags across all mounting points in one order.

Applications

Built for replacing worn flags without swapping out mounting hardware:

• Refreshing faded or torn flags on existing dowel or pole mounts
• Tie-off applications where a flag is roped to a rack or load rather than mounted on a pole
• Fleets keeping replacement flags in stock separate from full flag-and-dowel units

Installation

Attach the flag to your existing pole or dowel through the corner grommets, or run rope through the grommets to tie the flag directly to the load or rack. If you need a flag with the dowel already attached, see our flags with dowels. For complete load securement, check out our transport chain, load binders, winch straps, ratchet straps, and corner protectors.