A workhorse of the trucking and trailering world, this 4" x 20' ratchet strap in yellow uses a geared take-up mechanism rather than hand tension alone, so you can cinch a load down firmly and evenly. It's finished with a heavy-duty chain extension that pairs the strength of transport chain with the softness of webbing at the anchor point. Sold as a 90-pack.

Key Features

• Industrial-grade polyester webbing with a tight weave that holds up under repeated abrasion and rough handling
• Heat-sealed webbing ends that resist fraying so the strap keeps its finished edge over years of use
• Chain extension end hardware that lets you route around rub rails or stake pockets without putting wear on the webbing itself
• Corrosion-resistant zinc-plated hardware built for outdoor and roadside use
• Tagged and stenciled with break strength and working load limit information to support compliance with FMCSA and DOT regulations, CVSA and WSTDA guidelines, and North American cargo securement standards

Applications

• Landscaping, construction, and job-site equipment transport
• Moving and general hauling with pickup trucks and trailers
• Everyday towing and utility trailer use
• Flatbed and open-trailer freight hauling

Installation

Wrap the fixed end around the anchor point and feed the free end through the ratchet mandrel, pulling out slack by hand before ratcheting. Tighten in small increments until the load is secure, then close and lock the ratchet handle. Confirm hooks are properly seated on rated anchor points, stay within the strap's working load limit, and re-check tension after the first few miles.