A workhorse of the trucking and trailering world, this 4" x 20' ratchet strap in yellow uses a geared take-up mechanism rather than hand tension alone, so you can cinch a load down firmly and evenly. It's finished with a wide flat hook that distributes tension across rub rails and trailer edges. Sold as a 2-pack.

Key Features

• Densely woven polyester webbing that stands up to abrasion, tearing, and everyday wear better than lighter-duty straps
• Heat-sealed webbing ends that resist fraying so the strap keeps its finished edge over years of use
• Built-in defender at the hook to reduce webbing wear at the point of contact
• Zinc-plated hardware that stands up to weather and everyday corrosion
• Tagged and stenciled with break strength and working load limit information to support compliance with FMCSA and DOT regulations, CVSA and WSTDA guidelines, and North American cargo securement standards

Applications

• Securing lumber, pipe, and other bundled materials
• Everyday towing and utility trailer use
• Flatbed and open-trailer freight hauling
• Moving and general hauling with pickup trucks and trailers

Installation

Wrap the fixed end around the anchor point and feed the free end through the ratchet mandrel, pulling out slack by hand before ratcheting. Tighten in small increments until the load is secure, then close and lock the ratchet handle. Confirm hooks are properly seated on rated anchor points, stay within the strap's working load limit, and re-check tension after the first few miles.