Built around 4" x 30' of low-stretch polyester webbing, finished in black, this ratchet strap gives you mechanical leverage instead of relying on arm strength alone to cinch down a load. End hardware is a heavy-duty chain extension that pairs the strength of transport chain with the softness of webbing at the anchor point. It carries a rated capacity of 24,000 lb. Sold as a 2-pack.

Key Features

• Heavyweight polyester webbing woven with more picks per inch than typical straps on the market, for a webbing that resists abrasion, tearing, and cutting
• Cleanly heat-sealed ends that stop fraying before it starts, extending the working life of the strap
• Chain extension end hardware that lets you route around rub rails or stake pockets without putting wear on the webbing itself
• Zinc-plated hardware that stands up to weather and everyday corrosion
• Tagged and stenciled with break strength and working load limit information to support compliance with FMCSA and DOT regulations, CVSA and WSTDA guidelines, and North American cargo securement standards

Applications

• Everyday towing and utility trailer use
• Moving and general hauling with pickup trucks and trailers
• Flatbed and open-trailer freight hauling
• Landscaping, construction, and job-site equipment transport

Installation

Wrap the fixed end around the anchor point and feed the free end through the ratchet mandrel, pulling out slack by hand before ratcheting. Tighten in small increments until the load is secure, then close and lock the ratchet handle. Confirm hooks are properly seated on rated anchor points, stay within the strap's working load limit, and re-check tension after the first few miles.