This 4" x 50' ratchet tie-down combines rugged webbing with a ratcheting take-up mechanism, so you can tension a load precisely without guessing at how tight is tight enough. It comes fitted with a wide flat hook that distributes tension across rub rails and trailer edges.

Key Features

• Densely woven polyester webbing that stands up to abrasion, tearing, and everyday wear better than lighter-duty straps
• Cleanly heat-sealed ends that stop fraying before it starts, extending the working life of the strap
• Built-in defender at the hook to reduce webbing wear at the point of contact
• Corrosion-resistant zinc-plated hardware built for outdoor and roadside use
• Tagged and stenciled with break strength and working load limit information to support compliance with FMCSA and DOT regulations, CVSA and WSTDA guidelines, and North American cargo securement standards

Applications

• Landscaping, construction, and job-site equipment transport
• Securing lumber, pipe, and other bundled materials
• Moving and general hauling with pickup trucks and trailers
• Everyday towing and utility trailer use

Installation

Wrap the fixed end around the anchor point and feed the free end through the ratchet mandrel, pulling out slack by hand before ratcheting. Tighten in small increments until the load is secure, then close and lock the ratchet handle. Confirm hooks are properly seated on rated anchor points, stay within the strap's working load limit, and re-check tension after the first few miles.