A workhorse of the trucking and trailering world, this 4" x 30' ratchet strap in red uses a geared take-up mechanism rather than hand tension alone, so you can cinch a load down firmly and evenly. It's finished with a wide flat hook that distributes tension across rub rails and trailer edges. Sold as a 2-pack.

Key Features

• Industrial-grade polyester webbing with a tight weave that holds up under repeated abrasion and rough handling
• Cleanly heat-sealed ends that stop fraying before it starts, extending the working life of the strap
• Built-in defender at the hook to reduce webbing wear at the point of contact
• Corrosion-resistant zinc-plated hardware built for outdoor and roadside use
• Tagged and stenciled with break strength and working load limit information to support compliance with FMCSA and DOT regulations, CVSA and WSTDA guidelines, and North American cargo securement standards

Applications

• Everyday towing and utility trailer use
• Securing lumber, pipe, and other bundled materials
• Flatbed and open-trailer freight hauling
• Landscaping, construction, and job-site equipment transport

Installation

Wrap the fixed end around the anchor point and feed the free end through the ratchet mandrel, pulling out slack by hand before ratcheting. Tighten in small increments until the load is secure, then close and lock the ratchet handle. Confirm hooks are properly seated on rated anchor points, stay within the strap's working load limit, and re-check tension after the first few miles.